Faux Leather Strap Tutorial

In one of my latest patterns - the Zinnia bag -  I provide instructions on how to sew faux leather straps. I thought that sharing my technique would be extremely helpful as I get so many questions about sewing with faux leather.

With the right tools, you do not need to be afraid of faux leather! My one recommendation is this: get a walking foot attachment for your sewing machine. You will not regret it. I realize they are expensive but I have used my walking foot in so many projects now, it has paid itself off time and time again. It is not just for quilting. It deals with sticky materials such as vinyl and faux leather much better than a teflon foot. It also sews PUL, ProCare and Ripstop nylon beautifully!

Without further delay, here are my instructions for the faux leather strap taken directly from my Zinnia sewing pattern. These instructions are for shoulder straps but you can apply the same technique if you are making a longer adjustable cross body strap.

Start by cutting out your faux leather. You will need:

• (4) pieces faux leather 22 inches W x 2 inches H
• (4) pieces faux leather 5 inches W x 2 inches H

You will also need (4) 1-inch O rings - 2 for each shoulder strap.

Take one of the shorter strap pieces and draw a line through the centre horizontally.

 

Now fold in one half of the strap piece in towards the centre line you just drew and sew it

in place. Keep folding and sewing as you go until you’ve sewn that whole side.

 

Do the same for the other side.

Now pass the piece of strap through one of the O-rings and sew both ends together.

Repeat steps 1-4 for the other 3 short strap pieces. Now take 2 of the longer faux leather strap pieces and draw a horizontal line through the centre of the strap.

Now take the 2 pieces and sew the short ends RST.

Open up the seam you just sewed and topstitch the seam allowance down on both sides.

Now pass that strap piece through 2 of the O-rings with the shorter strap pieces you

created in steps 1-4.

Sew together the other 2 short strap ends RST. Once again, sew down the seam

allowance on both sides of the 2nd seam.

Like you did for the short strap pieces, you need to sew down one half of the strap

towards the centre line you drew. You will need to move the O-rings as required as you

are sewing. Sew down the other half also.

Now you should have one long strap loop. Place your O-rings at opposite ends of the

loop (I place them at the seams on the strap) and then clip the 2 sections of strap together

to keep them in place.

Now you are going to sew the strap halves together to create one strap with 4 thicknesses

of faux leather and the open section sandwiched inside. You will sew one rectangular

shaped seam with a 1/8” seam allowance.

You should end up with a strap that looks like this with 4 lines of stitching:

Repeat the same steps to create a second strap and you are done! You just need to sew them onto your bag. To attach your straps to your bag, you need to measure equal distance from the outer

edge of each side of the top of your bag's exterior and baste stitch your strap in place. Make sure you

do not attach your straps twisted!!

I hope this tutorial was helpful! Please do leave any questions you may have in the comments below and I will do my best to respond quickly.